We recommend servicing your valve every 3 years, or 20,000 miles, whichever comes sooner
This valve has been specifically designed for the Audi A1 1.4 Turbo (122hp) engine. This is a full replacement atmospheric blow-off valve that integrates seamlessly with the OEM electronics and results in absolutely no fault codes, no check engine lights, and no detriment to the performance of the vehicle in any way. Like our many TSI replacement valve options, the valve is fully engineered to remedy the failure issues associated with the OEM solenoid valves.
Please note this valve is only compatible with models that have a turbo mounted diverter valve as standard, as found in models up to and including most 2014 models. For recent 1.4 turbo models that do not have a standard turbo mounted diverter valve please see part number FMDV1.
Our valve uses full billet alloy construction with a piston based internal design that provides significantly improved reliability over the OEM valves, along with lightning fast response.
In The Box:
1 x FMDVA1TSI Valve
1 x Wiring Harness
1 x Solenoid, Bracket, and Screws
1 x 2000mm Length of 4mm Vac Hose
1 x Skoda Vacuum Tap
2 x M5 x 35 Self Tapper Screw
1 x Uprated Blue Spring
10 x Cable Ties
1 x Instructions
1 x Forge Keyring and Sticker
If you wish to tune this product to fit the needs of your engine, please see the spring tuning kit below.
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please contact our customer service team.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.
Shipping Charges & Services
We will contact you after your order is placed to advise of available shipping services and costs and to take payment from you.