We recommend servicing your valve every 3 years, or 20,000 miles, whichever comes sooner
This is a piston design bypass valve that is a direct replacement for the original fitment. This valve gives greater longevity than the diaphragm (OEM) valves but also benefits from its ability to be fitted with different springs when the boost pressure has been increased or the engine has been modified.
Please note that if your vehicle has the valve show in Figure 1 then this valve will fit your application, however the valve shown in figure 2 will not be compatible with the Forge valve. We have seen this change on vehicles that are produced post 2016 so please make sure to check before you purchase your Forge valve.
*To avoid the possibility of a P0101 trouble code, the ECM must be reprogrammed with a tune optimised for atmospheric discharge.
In The Box:
1 x FMDVCS14A Valve
1 x Uprated Yellow Spring
1 x Forge Sticker
Check your vehicle compatibility: Click here
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
Product ReviewsBe the first to review this product
Want to leave a review?
Login Register FREE!
Blow Off Valve for Ford Focus RS MK3 & Vauxhall Adam, Astra, Corsa, and more
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please contact our customer service team.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.
Shipping Charges & Services
We will contact you after your order is placed to advise of available shipping services and costs and to take payment from you.