This induction kit is for the Mk5 Golf R32. The filter is a PiperCross high flow Foam cone filter housed in a carbon fiber composite enclosed canister that connects directly to the an intake pickup at the front of the vehicle with an application specific inlet scoop. Everything is connected via high quality silicone couplers. The system creates a true ram air effect, and will only see airflow from outside the vehicle with absolutely no hot air from within the engine that could reduce power. We have dyno tested this kit, and have seen gains as high as 10 peak wheel horsepower improvement over the stock airbox and filter on Stage 2 tuned vehicles. Whilst Power gains may vary depending on your modifications and level of tune, this kit will offer a significant improvement over the original air box*
*Please note some models have a noise resonator connected to the air intake pipe that will have to be disconnected and left unused when installing the Forge Motorsport induction kit. This will however not detract from the performance of the induction kit
*Please note - the Pipercross filter is excluded from the Forge lifetime warranty*
Please watch our video on how to fit an air filter without damaging it.
DO NOT OVER TIGHTEN
When fitting the filter to its counterpart please ensure you do not over tighten the hose clamp connecting them. Doing so could result in the part being crushed, leading to fitment and/or performance issues. The recommended torque setting for this hose clamp is 2-2.4Nm
Please Note: In line with our policy to constantly review, revise, and improve our product range, the appearance of the product you receive may differ from the one advertised.
All Forge Motorsport products come with a limited lifetime warranty. All warranty claims must be accompanied by the original proof of purchase to enable us to help you. Failure to supply this proof will result in your claim or enquiry being denied.
For further information, please contact our customer service team.
Do not use aggressive (acidic) car cleaning products, particularly traffic film remover solutions or shampoos to clean your intercooler, radiator or oil cooler. The use of these products can damage Forge Motorsport cooling systems and invalidate your warranty. These are often found at car washes. A light, warm, soapy solution (free of harsh acidic cleaning compounds) should be used to clean you cooler and thoroughly rinsed away. We recommend that you should inspect your product on a regular basis for bent and/or crushed fins. Any bent fins should be carefully straightened to allow ambient air to pass through the core face. At the time of installing your Forge radiator, an approved coolant must be used and added to the coolant system. Be sure you never mix coolant and always use distilled water.
Shipping Charges & Services
We will contact you after your order is placed to advise of available shipping services and costs and to take payment from you.